This is a working overview of intranasal delivery, written for readers who want more than a one-paragraph summary but less than a textbook.
Reviewed 2026-02-11. Anything still debated is marked as such rather than presented as settled.
Handling follows standard practice for research peptides. Material is weighed in a low-humidity environment because the powder absorbs atmospheric moisture. Purity is reported as the percentage area of the main peak in a chromatogram, with specifications commonly set at 95 percent or higher; values below that threshold indicate the presence of truncated or modified species. Residual trifluoroacetate from purification is often present and may affect mass balance. Certificates of analysis should state the analytical method, the column and gradient used, and the lot-specific retention time so that results can be compared across suppliers.
Identity and purity of selank are established with reversed-phase high-performance liquid chromatography coupled to mass spectrometry. The peptide elutes from C18 columns with acetonitrile gradients in water containing trifluoroacetic acid or formic acid, and detection is usually performed by ultraviolet absorbance near 214 nm. Electrospray ionization in positive mode gives a doubly protonated ion near m/z 377, consistent with a mass of about 752 Da. Amino acid analysis or tandem mass spectrometry of fragment ions confirms the sequence. Because the molecule has no aromatic residues, it lacks a usable 280 nm chromophore, so low-wavelength detection or mass spectrometry is required.
Peptide bonds in selank are susceptible to hydrolysis under strongly acidic or basic conditions, and the terminal proline residues are vulnerable to exopeptidase activity in biological samples. Lyophilized powder stored dry at -20 °C typically remains stable for extended periods, whereas aqueous solutions degrade faster and may lose measurable purity within days to weeks depending on pH, temperature, and microbial load. Repeated freeze-thaw cycles promote aggregation and adsorption to container surfaces. For analytical work, solutions are usually prepared fresh, kept cold, and used within a single working day.
Lyophilised material kept dry at minus 20 degrees Celsius or colder is the most stable form, and suppliers commonly state a shelf life of two years or more under those conditions. Once dissolved, degradation accelerates through hydrolysis and deamidation, particularly at alkaline pH or elevated temperature. Working solutions are usually divided into single-use aliquots to avoid repeated freeze-thaw cycles. The choice of reconstitution solvent affects both stability and the ionic strength of the final preparation.
Reverse-phase high-performance liquid chromatography with ultraviolet detection near 214 nanometres is the standard purity method. Mass spectrometry, typically electrospray ionisation, confirms identity through the expected mass-to-charge pattern. Amino acid analysis can verify composition independently. Chiral purity requires separate techniques such as derivatisation followed by chromatographic separation, and such data are rarely reported for research-grade material.
| Property | Value | Notes |
|---|---|---|
| Identity confirmation | Reversed-phase HPLC retention time versus reference standard | Retention depends on column, gradient, and ion-pairing agent |
| Mass confirmation | Electrospray or MALDI mass spectrometry | Doubly protonated ion near m/z 377 is consistent with about 752 Da |
| Typical purity specification | 95 percent or higher by chromatographic peak area | Lower values suggest truncated or modified peptide species |
| Storage of lyophilized powder | -20 °C, desiccated, protected from light | Powder tolerates long storage better than solution |
| Storage of solution | 2-8 °C for short periods | Freeze-thaw cycling promotes aggregation and surface adsorption |
Selank is a synthetic heptapeptide with the sequence Thr-Lys-Pro-Arg-Pro-Gly-Pro. It was designed as a stabilized analogue of tuftsin, a naturally occurring tetrapeptide fragment derived from the immunoglobulin heavy chain. The additional Pro-Gly-Pro segment at the carboxyl terminus is intended to slow enzymatic cleavage. The compound is usually described in the literature as a synthetic peptide with anxiolytic and cognitive-related activity, a label that reflects a research context rather than an approved therapeutic category.
Most published work on selank originates from a small number of research groups in the Russian Federation. A large share of that record appears in Russian-language journals, which limits access for readers who rely on English-indexed databases. Independent replication by laboratories outside the original research network is sparse in publicly available sources. This concentration of origin and language is a frequently noted feature when the compound is summarized in broader reviews of synthetic peptides.
Selank is studied chiefly as an animal-model anxiolytic with proposed secondary effects on memory and immune signaling. Reported mechanisms include modulation of the GABA-A receptor complex, inhibition of enkephalin-degrading enzymes, and shifts in monoamine turnover within limbic structures. Some experiments describe increased expression of brain-derived neurotrophic factor in the hippocampus after repeated dosing. No single molecular target has been confirmed, and the peptide does not bind any receptor with the selectivity typical of a conventional small-molecule drug. Mechanism therefore remains a set of hypotheses rather than an established pathway.
Laboratory work relies on standard behavioral paradigms. Rodents are tested in the elevated plus maze, open field, and passive avoidance tasks, with outcomes compared against diazepam or vehicle controls. Intranasal dosing is used most often because it bypasses first-pass metabolism, though intraperitoneal and intravenous routes also appear in published protocols. Biochemical endpoints include tissue BDNF concentrations, cytokine levels, and monoamine metabolites. Human data are limited to small Russian trials reporting reduced anxiety scores; most were not prospectively registered, and few employed independent outcome assessment.
Measuring peptide exposure inside the brain is technically difficult. Selank is degraded rapidly in plasma, and assays must separate intact peptide from fragments, which favors targeted mass spectrometry over immunoassays alone. Reported half-lives are short, on the order of minutes, so effects observed hours later are attributed to downstream signaling rather than to the parent compound. Blood-brain barrier permeability is debated and rarely quantified directly. Gaps include absent dose-response characterization, inconsistent reporting of purity, and almost no pharmacokinetic data from human participants.
Vaginal gels are forms of medication that are water-based. They are applied using a plastic applicator to distribute the gel throughout the length of the vaginal canal. These gels tend to have release kinetics that are fast acting, which makes them useful for treatment of irritations. Antibiotics are often distributed in the form of a gel for treatment of common infections, including sexually transmitted infections (STIs). The gels also have the benefit of being lubricating, which grants additional relief to symptoms of dryness and itching that is common with vaginal infections. Gels that are in the form of liposomal structure have been shown to retain substances for extensive periods of time, making them useful for slow release of drugs administered through the cervical drug delivery route
Droplet countercurrent chromatography (DCCC) was introduced in 1970 by Tanimura, Pisano, Ito, and Bowman. DCCC uses only gravity to move the mobile phase through the stationary phase which is held in long vertical tubes connected in series. In the descending mode, droplets of the denser mobile phase and sample are allowed to fall through the columns of the lighter stationary phase using only gravity. If a less-dense mobile phase is used it will rise through the stationary phase; this is called ascending mode. The eluent from one column is transferred to another; the more columns that are used, the more theoretical plates can be achieved. DCCC enjoyed some success with natural product separations but was largely eclipsed by the rapid development of high-speed countercurrent chromatography. The main limitation of DCCC is that flow rates are low, and poor mixing is achieved for most binary solvent systems.
Because even the longest-lived isotope of technetium has a relatively short half-life (4.21 million years), the 1952 detection of technetium in red giants helped to prove that stars can produce heavier elements.
=== Pharmacokinetics === After oral intake, ertugliflozin is practically completely absorbed from the gut and undergoes no relevant first-pass effect. Highest blood plasma concentrations are reached after one hour. When in circulation, 93.6% of the substance are bound to plasma proteins. Ertugliflocin is metabolised mainly to glucuronides by the enzymes UGT1A9 and UGT2B7. Cytochrome P450 enzymes play only a minor role in its metabolism. The elimination half-life is estimated to be 17 hours. 40.9% are eliminated via the feces (33.8% in unchanged form and 7.1% as metabolites) and 50.2% via the urine (1.5% unchanged and 48.7% as metabolites). The high proportion of unchanged substance in the feces is probably due to hydrolysis of the metabolites back to the parent substance.
Sources: en.wikipedia.org
Italy was a postwar operator of P-51Ds; deliveries were slowed by the Korean War, but between September 1947 and January 1951, by MDAP count, 173 examples were delivered. They were used in all the AMI fighter units: 2, 3, 4, 5, 6 and 51 Stormo (wing), plus some employed in schools and experimental units. Considered a "glamorous" fighter, P-51s were even used as personal aircraft by several Italian commanders. Some restrictions were placed on its use due to unfavorable flying characteristics. Handling had to be done with much care when fuel tanks were fully used, and several aerobatic maneuvers were forbidden. Overall, the P-51D was highly rated even compared to the other primary postwar fighter in Italian service, the Supermarine Spitfire, partly because these P-51Ds were in very good condition in contrast to all other Allied fighters supplied to Italy. Phasing out of the Mustang began in mid-1958. Japan The P-51C-11-NT Evalina, marked as "278" (former USAAF serial: 44-10816) and flown by 26th FS, 51st FG, was hit by gunfire on 16 January 1945 and belly-landed on Suchon Airfield in China, which was held by the Japanese. The Japanese repaired the aircraft, roughly applied Hinomaru roundels and flew the aircraft to the Fussa evaluation center (now Yokota Air Base) in Japan. Netherlands
=== Receptor ectodomain shedding === When the extracellular domain of GHR is proteolytically cleaved (see: proteolytic cleavage) from the rest of the receptor protein, the extracellular domain is released as the water-soluble, carrier protein GHBP. As the extracellular domain alone, the polypeptide consists of 246 amino acids and is roughly 60 kDA in size. This cleaving process is called “receptor ectodomain shedding. In humans and rabbits, tumor-necrosis factor alpha converting enzyme (T.A.C.E.) is postulated to play a significant role in the post-translational processing activity that sheds GHBP from GHR. Studies show that this activity primarily occurs in the liver. When growth hormone is bound to two dimerized GH receptors, the shedding activity is inhibited. This occurs because when the ligand binds to the receptors, a conformational change occurs in them that potentially blocks the proteolytic activity of T.A.C.E.
mTOR Complex 2 (mTORC2) is composed of mTOR, rapamycin-insensitive companion of mTOR (RICTOR), MLST8, and mammalian stress-activated protein kinase interacting protein 1 (mSIN1). mTORC2 has been shown to function as an important regulator of the actin cytoskeleton through its stimulation of F-actin stress fibers, paxillin, RhoA, Rac1, Cdc42, and protein kinase C α (PKCα). mTORC2 also phosphorylates the serine/threonine protein kinase Akt/PKB on serine residue Ser473, thus affecting metabolism and survival. Phosphorylation of Akt's serine residue Ser473 by mTORC2 stimulates Akt phosphorylation on threonine residue Thr308 by PDK1 and leads to full Akt activation. In addition, mTORC2 exhibits tyrosine protein kinase activity and phosphorylates the insulin-like growth factor 1 receptor (IGF-1R) and insulin receptor (InsR) on the tyrosine residues Tyr1131/1136 and Tyr1146/1151, respectively, leading to full activation of IGF-IR and InsR.
Sources: en.wikipedia.org
Identity is confirmed by matching the retention time in reversed-phase chromatography against a reference standard and by measuring the molecular mass with mass spectrometry. Tandem mass spectrometry or amino acid analysis can verify the sequence of the seven residues. Because the peptide contains no aromatic amino acids, detection at 280 nm is not useful.
Lyophilized powder is normally stored desiccated at -20 °C, protected from light and moisture. Powder kept under these conditions is generally stable for long periods. Solutions are less stable and are usually prepared immediately before use.
A purity value from one chromatographic method does not capture every possible impurity. Related peptides with similar retention behavior, counterions, and residual solvents may not appear in the same analysis. Independent testing with an orthogonal method provides stronger assurance of identity and content.
Dry powder is best kept sealed, protected from light, and held at minus 20 degrees Celsius or below. Desiccant packaging helps limit moisture uptake because the material is hygroscopic. A sealed vial should be allowed to equilibrate to room temperature before opening to reduce condensation.